Introduction

Use this guide to replace the fingerprint sensor in your Framework 16" laptop.

Note: the laptop used in this guide is a generic setup of one US keyboard, one numpad module, and two touchpad spacers. Your setup might vary, but the procedure should remain the same.

  1. yhbS1LqdqJHUFVXe
    yhbS1LqdqJHUFVXe
    HZuhH6VoPDvd5lfy
    • The fingerprint reader cover screws are marked 1–3. You don't need to follow this order, but you can use it to help keep track of the screws you've removed.

    • Use your Framework Screwdriver to remove the three 2.0 mm‑long Phillips screws securing the fingerprint reader cover.

  2. FFfGMlkKiLjcP4TV
    FFfGMlkKiLjcP4TV
    aKXt1l1WCTjf5dg3
    ULMJjpThuVBYgUkW
    • Use the flat end of your Framework Screwdriver to lift the fingerprint reader cover and remove it.

  3. LSW2jSLQD6JsgbH2
    LSW2jSLQD6JsgbH2
    LjNXxkjfQI2WHy4V
    qtXIBVLTJY3skrYB
    • Lift the fingerprint reader out of its slot in the ventilation plate and remove it.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers Community for help.

Alex Diaz-Kokaisl

Member since: 16/01/22

215075 Reputation

0 comments