Introduction

Use this guide to replace the touchpad, or touchpad module, in your Framework 16" laptop.

Note: the laptop used in this guide is a generic setup of one US keyboard, one numpad module, and two touchpad spacers. Your setup might vary, but the procedure should remain the same.

  1. n3dlIsBN2lPrCToZ
    n3dlIsBN2lPrCToZ
    XXZZ3WiGghUFLQBb
    dKJ3sQcj6bd4RYai
    • Use your fingernail to pull out the two Input Module latches and unlock them.

    • The latch will show red if it's unlocked.

  2. UdvOwfAwUSJCPcx4
    UdvOwfAwUSJCPcx4
    1Vunb2PRgeCo52JM
    Ixvsqgp1HwSZIHB1
    • Use your fingers to slide the Touchpad Module toward the bottom edge of the laptop and disconnect it.

    • If you're having trouble, check if the Input Module latches are properly unlocked.

    • Lift the Touchpad Module and remove it.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers Community for help.

Alex Diaz-Kokaisl

Member since: 16/01/22

215075 Reputation

0 comments