Introduction

Monitors often lose contrast or brightness after years of intense use, often due to capacitors.

The problem can be solved with little expense and a little skill.

  1. G5PXRfucJMWCX1Bl
    • Unplug all.

    • Use a PH2 driver to remove the four screws securing the stand.

  2. LskYaiDpDWm5V6mJ
    • Use a PH2 driver to remove the five screws securing the back panel.

    • Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from.

  3. nEdQAWEmZ45pdySd
    • Insert the flat end of a spudger into the gap between the back panel and the shell.

    • Gently pass around the entire frame of the monitor, you will hear several clicks.

    • Skip the corners if you have trouble. It will open anyway.

  4. dr2P5PVcHlYwr5rH
    • Hold one of the two short sides and lift the panel.

    • During reassembly, press along the edges of the back panel to snap it into place.

  5. JUODPMFoyRZuMIPE
    JUODPMFoyRZuMIPE
    4Bc4NEnh1CX5kZA6
    • Unplug connectors

    • Unstick the tape

    • Flip up the metal case

  6. E6ZptEDI2FhFDE5Z
    E6ZptEDI2FhFDE5Z
    l2cJ131M4HKN6QcN
    • Use a PH2 driver to remove the five screws securing the power board.

    • Unplug the "rainbow" connector.

    • Remove the plastic cover.

  7. OeYSN5keC6TxExk5
    OeYSN5keC6TxExk5
    MkwoYYyngVYoHn65
    TQNTafuC6rOCOYYo
    • Inspect the board paying attention to the capacitors

    • These two have no bulges, they look normal. If you have a tester you can test them.

    • These two are a little swollen and need to be replaced. If you have a tester you can test them.

    • Pay attention to Voltage and Capacity.

  8. FkcAp4EcnTDST4Cl
    FkcAp4EcnTDST4Cl
    mVeB1vOIR5SMl3RB
    • Look where the old capacitors are placed on the PCB and unsolder them

  9. yMlEDRfDVfnMJF6P
    yMlEDRfDVfnMJF6P
    GZ5eOKpEQ2fdfKUm
    • Insert the new capacitors.

    • Respect the polarity of the capacitors. Otherwise they will explode.

  10. QJUdQ5KPHmMsvaG3
    QJUdQ5KPHmMsvaG3
    dhRqEtBFJwQdGLdo
    • Solder the new capacitors, then cut off the excess wire.

    • Finished. To reassemble, go back from point 6 to point 1.

Conclusion

To reassemble your device, follow these instructions in reverse order.

saverio92sx

Member since: 07/06/22

295 Reputation

0 comments